Vibe Gear Track Base

Vibe Gear Track Base

The four brass inserts on your Yellowfin 100 in front of the cupholder, is made specifically to put a Vibe Gear Track base there, so you can install any accessory! The screws are M6x18mm. 
https://vibekayaks.com/products/vibe-gear-track-base
    • Related Articles

    • Vibe Top Loading Gear Track Instructions

      Top-loading gear tracks will allow you to easily attach external rod holders, camera mounts, gear retractors and more, so that any essential gear is close-at-hand when you need it most. No tools are needed, as the gear tracks come pre-installed. ...
    • Is the Vibe Switchback seat that comes with the Cubera 120 compatible with the Summit base?

      Great question. No — the Vibe Switchback seat that ships with the Cubera 120 is not compatible with the Summit base. The way the legs fold does not allow for mounting to the summit base. Best regards, Vibe Kayaks
    • Water sloshing inside the base pod of my Vibe Shearwater 125

      This is a question we get from time to time after a long fishing trip, especially in cold water or after rinsing the kayak. How does water get inside the base pod? The base pod on the Shearwater is sealed under normal use but small amounts of water ...
    • Impulse Drive Re-Gear Kit Manual

      Your Impulse Drive Re-gear Kit comes with 3 different gear ratios 6:1, 8:1, and 10:1. With each step up in gear ratio you will gain more revolutions of the propeller per revolution of the pedals, this will come at the expense of effort needed to ...
    • Adjusting The Vibe Foot Braces

      Adjusting Vibe Foot Braces is simple: No tools are needed, as the foot braces come pre-installed, and adjustment can be done by hand. Instructions: Pull the trigger on the back of the foot brace. Slide the brace into the best position for you (we ...